Inserting A Sim Card - GE NX-10 Installer Manual

Inserting a SIM card

!
#
%
CAUTION: You must be free of all static electricity when handling electronic components.
Power down the system before inserting the SIM Card.
1.
Locate the SIM card holder ! on the board.
2.
Open the SIM card holder by sliding the clip as shown in " and lifting the holder.
3.
The SIM card holder opens #.
4.
Slide the SIM card into the holder using the guides. Make sure the contacts (gold pads)
5.
facing the circuit board and the angled corner face out $.
Make sure that the SIM card is placed properly in the holder and close the SIM card
6.
holder %.
Slide the clip back to the original position as shown in &.
7.
Power up the system. Do not enter programming mode until the SIM card selects the
8.
network operator. The SIM card automatically selects a network operator when enrolled
on the network. To manually select an operator, enter the relevant network operator in
GSM Operator>Operator Selection. See Appendix A for a list of operator ID codes.
Most SIM cards contain a pre-programmed SMS service center address and under normal
circumstances, this should not be changed. If you do need to change it, include the international
country prefix using a '+' instead of leading zeros.
Bus
Err
GPRS
SIM
Acti e
Err Reportin
OPEN
g
PSU
Err
GSM in
Use
OPEN
LOCK
LOCK
1
2
3
4
5
OPEN
LOCK
OPEN
LOCK
"
OPEN
LOCK
$
OPEN
LOCK
&
OPEN
LOCK