Setting Up Polling; Upload/Download - GE NX-10 Installer Manual

Setting up polling

You can set up the GSM/GPRS module to report periodically to a receiver that it is still active. This
is known as polling. Polling is more frequent than a daily test call but less frequent than continuous
monitoring. If you configure a very short polling time, polling occurs very frequently and can
generate large quantities of data. When setting the polling time, you should consider the speed of the
GPRS network, possible connection delays and the cost of data transmission.
•
Navigate with the
Reporting>Receiver Polling, select On and press OK to enable polling.
•
Navigate with the
Reporting>Polling Time and enter the time in minutes (0-255) and press OK to set
the TCP/IP polling time.

Upload/download

GSM CSD connection.
The upload/download access code is set on the control panel in
Communications>Up/Download>Download Access Code. The following example configures the
GSM/GPRS module GPRS module to answers calls from phone number 5666666 only. The PC
initiates the upload/download session.
Navigate with the
1.
connection type. This must be done before the phone number and IP address can be
programmed.
Navigate with the
2.
Scroll to Remote Initiated>Enabled and press OK.
3.
The keypad beeps once to accept the change and returns to Remote Initiated.
4.
Scroll to Phone Number and press OK.
5.
Press # to clear the current value.
6.
Enter 5666666 and press OK.
7.
The keypad beeps once to accept the change and returns to Phone Number.
8.
Navigate to Up/Download>Allow Calls From and select Known Phone Number.
9.
You must configure the GSM/GPRS module data phone number on the upload/download
10.
PC. Ask your network provider for this number.
You must also configure the GSM modem on the upload/download PC. Select
11.
Program>Setup>GSM Modem setup. Enter S7=60S10=255X0T+MS=9,1,9600,9600 in
the Initialization string 2 field.
GPRS connection.
The connection is made via a TCP/IP network. Instead of a phone number, an IP address is set. The
Callback Required and Allow Calls From options are ignored.
Navigate with the
1.
keys to NX-7002 Module>Reporting>TCP/IP
keys to NX-7002 Module>Reporting>TCP/IP
keys to Up/Download>Connection Type>CSD. This sets the
keys to NX-7002 Module>Up/Download and press OK.
keys to Up/Download>Connection Type>TCP/IP. This sets the
NX-10 Installers manual
191