Chapter A4 Programming Guidelines; Getting Started; Country Codes - GE NX-10 Installer Manual

Chapter A4

Getting started

This chapter describes a NX-10 installation with the menu driven keypad allowing you to program
the system easily using a menu structure.

Country codes

The NX-10 has the ability to set different "country codes". Each country code has specific default
settings. When you start your system for the first time (see Powering up the system below) and select
keypad defaults during the initial keypad setup, the respective country code is also set up
automatically for the panel. Once the country code has been selected, it will remain set, even after an
installer reset. When changing the country code during programming, all existing programming will
be cleared to the defaults for that country
Note: For a detailed first keypad installation description, see Wireless keypad learning-in procedure on page 28.
The table below lists the default country codes.
Table 5. Country codes
Code
0 No country (factory setting)
1
2
3
4
5
6
7
8
9
10
11
17
50
For all the countries there are the following default codes:
Table 6. Default codes
User code
1234
Note: Press NO key to clear any incorrectly entered user code or other information.
Programming guidelines
.
Country
Holland
Belgium / Poland
Sweden
Italy
Spain
Greece
South Africa
Israel
Spain (PRSGR)
Turkey
France
Turkey Pronet
US
Installer code
9713
Download access code
84800000