GE NX-10 Installer Manual page 112

For a 3+1 format, only the segment 1 digit (tens) will be sent.
LOCATION 77 - OPENING COMMUNICATOR CODE, SLOW SPEED FORMATS ONLY (8 segments,
numerical data)
Location 77 contains the tens digit for a 4+2 and 3+1 format if "Opening Reporting" is enabled. The
ones digit is the ones digit of the user number that did the opening. If the user is greater than 9, the
numbers will begin repeating (e.g. code 6 = 6, code 45 = 5).
This location contains 8 segments. Any segment left as "0" will follow the segment 1 selection.
If you need to report openings and closings with a unique code per user, Contact ID or SIA format
must be used.
Segment 1
Opening code for partition 1
Segment 2 Opening code for partition 2
Segment 3 Opening code for partition 3
Segment 4 Opening code for partition 4
LOCATION 78 - CLOSING COMMUNICATOR CODE, SLOW SPEED FORMATS ONLY (8 segments,
numerical data)
Location 78 contains the tens digit for a 4+2 and 3+1 format if "Closing Reporting" is enabled. The
ones digit is the ones digit of the user number that did the opening. If the user is greater than 9, the
numbers will begin repeating (e.g. code 6 = 6, code 45 = 5).
This location contains 8 segments. Any segment left as "0" will follow the segment 1 selection.
If you need to report openings and closings with a unique code per user, Contact ID or SIA format
must be used.
Segment 1
Closing code for partition 1
Segment 2 Closing code for partition 2
Segment 3 Closing code for partition 3
Segment 4 Closing code for partition 4
LOCATION 79 - AUTOTEST COMMUNICATOR CODE, SLOW SPEED FORMATS ONLY (2 segments,
numerical data)
Location 79 contains the tens and ones digits for a 4+2 and 3+1 format that will be sent if "Autotest"
or "Manual Test" is enabled. Segment 1 contains the tens digit, and segment 2 contains the ones
digit.
For a 3+1 format, only the segment 1 digit (tens) will be sent.