Programming Locations For The Rf Receivers - GE NX-10 Installer Manual

Term
X-10 Address
Zone/User

Programming locations for the RF receivers

In the Table 19 you can find list of locations related to the output events. Please note, that
descriptions for locations 70, 71 and 72 given below for the output 1, pertain also to the respective
locations for the outputs 2 to 8.
Table 19. RF receiver location map – locations related to output events.
Output Location
70
1
71
72
73
2
74
75
76
3
77
78
4
79
80
Definition
option is set to Disabled, keypads do not wake up, and chime is not emitted.
Please note, that also other keypad settings can affect whether the acoustic
signal is actually emitted or not, for example, Keypad Features>Silent Keypad.
A menu entry that groups X-10 configuration options for IO modules.
Selects the zone or user number necessary to trigger an output. If this location
is programmed as a zero ("0"), any zone or user will activate the output (see
also location 68).
The zone/user filter is active only for following events: Burglary Alarm, Fire
Alarm, 24h Alarm, Zone Tamper (it filters out zones for all these events), and
Code Entry (it filters out users). For all other events this setting is ignored.
Segment Type
1 dec value
2 dec value
3 dec value
1 option
2 option
1 hex value
2 hex value
1 dec value
2 dec value
3 dec value
1 option
2 option
1 hex value
2 hex value
1 dec value
2 dec value
3 dec value
1 option
2 option
1 hex value
2 hex value
1 dec value
2 dec value
3 dec value
1 option
Description
Event number
Zone / user number
Time
Special configuration
Partition
X-10 unit code
X-10 house code
Event number
Zone / user number
Time
Special configuration
Partition
X-10 unit code
X-10 house code
Event number
Zone / user number
Time
Special configuration
Partition
X-10 unit code
X-10 house code
Event number
Zone / user number
Time
Special configuration
IO module
IO module 1
IO module 2