Defining Communication With A Central Station - GE NX-10 Installer Manual

Figure 17. Report codes menu
Report Codes
2.4.4.3 2.4.4.3.1
2.4.4.3.2
2.4.4.3.3
2.4.4.3.4
2.4.4.3.5
2.4.4.3.6
The control panel can report to a central station after all or specified events. Communication between
the control panel and the central station is monitored to ensure against damage or faults. The control
panel can also communicate with up/download software when a download session has been
established. To program control panel communication options, select Installer Menu>Control
Panel>Communications.

Defining communication with a central station

You can specify up to three central stations to which the control panel reports events. You can also
select the events to be reported to each station. For more information on setting up a communicator,
see Appendix 3, Communicator formats.
You can set a number of conditions that must be met before a communication session is established
between the control panel and the central station. To enable restore report options, you must enable
the advanced menu.
The following example configures the control panel to ring the central station three times before a
fail to communicate condition occurs for the Phone Number 1.
Ensure the advanced menu is enabled.
1.
Navigate with the
2.
Zone Types
2.4.4.3.1.1
Partition Reports
2.4.4.3. .1 2
Keypad
2.4.4.3.3.1
2.4.4.3.3.2
2.4.4.3.3.3
2.4.4.3.3.4
2.4.4.3.3.5
Power
2.4.4.3.4.1
2.4.4.3.4.2
2.4.4.3.4.3
Tamper/Fault
2.4.4.3.5.1
2.4.4.3.5.2
2.4.4.3.5.3
2.4.4.3.5.4
2.4.4.3.5.5
Miscellaneous
2.4.4.3.6.1
2.4.4.3.6.2
2.4.4.3.6.3
2.4.4.3.6.4
2.4.4.3.6.5
2.4.4.3.6.6
keys to Control Panel>Communications>Central Station and
(1) Day Zone
2.4.4.3.1.1.1
2.4.4.3.1.1.2
Zone Types 2 - 0 3
Same as above 2.4.4.3.1.1.3
(1) Partition 1
2.4.4.3.2. 1
2.4.4.3.2. 2
Partitions 2 - 4
Same as above
2.4.4.3.2. 3
2.4.4.3.2. 4
2.4.4.3.2. 5
2.4.4.3.2. 6
2.4.4.3.2.1.7
2.4.4.3.2.1.8
Duress Code
Keypad Aux 1 (Fire)
Keypad Aux 2 (Medical)
Keypad Panic
Keypad Tamper
For slow speed formats only
Mains Failure
Low Battery
Aux Overcurrent
For slow speed formats only
Box Tamper
Siren Tamper
Phone Line Cut
Expander Trouble
Fail to Communicate
For slow speed formats only
For slow speed formats only
NX-10 Installers manual
Event Code
SIA Code
CID Code
Restore
1.
Bypass
1.
Tamper
1.
Trouble
1.
Sensor Low Battery
1.
Sensor Lost
1.
Opening
Closing
For slow speed formats only
57