• Press and release the 'quad/scan' button until multiple
camera video streams appear on the screen.
2. Sequential (Scan)
• Displays each paired camera every 7-seconds.
• Press and release the 'quad/scan' button until a single camera
video stream appears.
• View individual camera continuously.
3. Manual (Single Camera View)
• Press and release the 'manual' button. Tap repeatedly to cycle
through all cameras paired to monitor.
LIVE VIDEO WITH 1
PRIORITY MOTION AND/OR
NOTE: See 'how-to' instructions in 'The Basics' section of
• WITHOUT notiﬁ cation alarm
...To be notiﬁ ed with the screen in stand-by mode
In addition to turning the screen back on when motion and/
or sound is detected, the screen will 'jump' to the applicable
camera. The screen will remain lit for approximately 15 seconds
after the video motion or sound stops.
...To be notiﬁ ed with the screen illuminated
• WITH notiﬁ cation alarm
...While the screen is ON
While in manual or scan view, sounds 4 beeping tones when
audio or video motion is detected. Alarm can be triggered
repeatedly for an indeﬁ nite period of time.
NOTE: Alarm only sounds when applicable camera is displayed on
...While the screen is in standby mode
In addition to turning the screen back on and beeping 4
tones when motion and/or sound is detected, the screen will
'jump' to the applicable camera. The screen will remain lit for
approximately 15 seconds after the video motion or sound stops.
RECORDING WITH OPTIONAL MICRO SD
card sold separately)
NOTE: Before recording, it's recommended to set the
correct date and time. Refer to the 'Settings' section
of the manual for instructions. When activated, the
directional keypad, 'menu' button, 'ok' button and
'volume' buttons are disabled. Not supported in
quad view (multi-screen).
1. Press and release the 'man' button on the right side of the
monitor. Recording will begin immediately and 'REC' will
appear ﬂ ashing on top of the display. Additionally, the name
of the recording is shown to the right of 'REC' in blue.
NOTE: Maximum recording time is 10 minutes of continuous motion
and/or sound detected by camera. After 10 minutes, the monitor will
record to a new ﬁ le if camera still detects motion and/or sound. The
task will repeat itself indeﬁ nitely until all storage space is consumed
(unless the overwrite feature is activated).
2. To stop recording, press and release
the 'man' button again. Both the name
and 'REC' on the display will disappear.
A new ﬂ ashing yellow icon will appear
indicating a new ﬁ le was recorded
and ready for playback.