Drive Belt - BOMBARDIER 1980 Shop Manual

REMOVAL & INSTALLATION
When removing a drive belt always mark the rotation
direction. Reinstall in same direction.
DRIVE BELT REMOVAL
Tilt cab and remove pulley guard. (Elite model: unlock
and raise driven pulley support). Open driven pulley by
twisting and pushing the sliding half. Hold in open position
then slip slackened belt over top edge of pulley. Slip belt
from drive pulley.
+
WARNING: Never start or run engine without drive
belt installed.
Elan, Spirit, Alpine, Elite
A
B
C
SECTION 05
SUB-SECTION 02 (DRIVE BELT)
DRIVE BELT
Everest, Futura,
Blizzard 5500, 7500, 9500,
Grand Prix Special
Super Sonic, Ultra Sonic
A.4
::..:.--
B. 5
C 6
Mirage, Citation
1 - Remove the belt guard.
2 -
Loosen the countershaft bearing retaining screw
and open the bearing cage.
(DRIVE BELT). PAGE 1