BOMBARDIER 1980 Shop Manual page 348

SECTION 08
SUB-SECTION 02, (FRAME)
FRAME WELDING
Steel frame:
- Electric Welding
- Amperage: 70-110 Amp.
- Voltage: 20-24 volts
- Rod: E-7014 (3/32")
Aluminum frame: (refer to specialized welding shop)
- Argon-oxygen I acetylen welding
- Rod: ER-4043 (3/32")
. . . CAUTION: When electrical welding is to be per-
'Y
formed anywhere on the vehicle, unplug the mul-
tiple connector at the electronic box prior to connecting
the welding wire to the vehicle. This will protect the
electronic box against damage caused by flowing cur-
rent when welding.
O
NOTE: This procedure applies to all electronic
Ignition systems.
(FRAME). PAGE 12
Unplug dUring
electrical welding
~
FRAME CLEANING
CJean frame. For aluminum frame use only" Aluminum
cleaner" and follow instructions on container. (Dursol
cleaner or equivalent).
Touch up ali metal spots where paint has been scratched
off. Spray all bare metal parts of vehicle will metal
protector.
SEATS
Elite model
To remove the backrest. unscrew the two (2) wing nuts
located in the engine compartment.