BOMBARDIER 1980 Shop Manual page 245

(
Install governor cup making sure that the shaft end rests
in govenor cup seating. Position retaining bolt with a new
locking tab then torque to 85 Nom (63 ft-Ibs).
_ CAUTION: Incorrect seating of shaft end in gover-
'fIf
nor cup can cause crankshaft bending. When
pulley is completely assembled always measure distance
of both pulley halves to make sure that the pulley is
properly installed. Distance must be 76 mm (3").
Push on sliding
half towards
governor cup
to remove
all possible slack
when measurmg
Lift rear of vehicle off the ground. Install drive belt and
pulley guard then start engine and apply throttle and
brake, 2-3 times. Stop engine and retorque retaining bolt.
Bend one side of locking tab over governor bolt.
SECTION 05
SUB-SECTION 03, (DRIVE PULLEY)
(DRIVE PULLEY). PAGE 17