BOMBARDIER 1980 Shop Manual page 262

SECTION 05
SUB-SECTION 05 (PULLEY ALIGNMENT)
- Bend the tab lock of the adjuster nut.
. . , CAUTION: Make sure the lock tab is secure in
" the driven pulley keyway.
Everest, Futura,
Blizzard 5500, 7500, 9500,
Grand Prix Special,
Super Sonic, Ultra Sonic
OFFSET X & Y 34 mm (1 11/32").
Floating type driven pulley requires a special procedure
to correctly measure offset.
- Install a 1/16" gauge between pulley and bearing
plate.
- Then measure offset (usual method).
IMPORTANT: Make sure driven pulley assembly is fully
seated against bearing flange when measuring offset.
~"
square bar
Length: 48 em (l 9
In.),
Nominal
distance
between
pulleys
iizsJ
T
"X"
T
"Y"
- Dimension "X" must never exceed dimension "Y".
- Oimension "Y" can exceed dimension "X" by 1.6
mm (1/16").
(PULLEY ALIGNMENT). PAGE 2 .
- Adjust the offset by adding or removing shims.
With 1 / 1 6" shim
In
place. push assembly
in against bearing plate
~
1/16/1 Shim
~
O
NOTE: To add or remove shims. pulley assembly
must be removed as per driven pulley removal
procedure.
- When alignment is completed. remove 1/16" gauge.
If pulley was removed:
Reinstall the pulley. outer shims. lockwasher and bolt.
Torque to 9 N'm (7 ft-Ibs).
IMPORTANT: Maximum free-play should not exceed
3
mm (l") .
. . , CAUTION: Always apply anti-seize compound
" (Loctite anti-seize lubricant P / N 413 70 1
a
00)
on the countershaft before final assembly.