BOMBARDIER 1980 Shop Manual page 52

SECTION 03
SUB-SECTION 02 (ENGINES)
BOTTOM END
CLEANING
Discard all seals and gaskets.
Clean all metal components in a non-ferrous metal
cleaner.
DISASSEMBLY
&
ASSEMBLY
General
Refer to Technical Data (02) and Engine tolerances
measurement (03-01) sections for some component
fitted tolerance. If necessary, refer to Drive Pulley section
(05-03) to remove drive pulley.
800000
not remove unless necessary.
To remove, heat slightly with a butane torch then pry
out using a screwdriver. '
To install, apply oil on outside diameter then use no.
420276930 pusher for magneto side and no.
420276940 pusher for P.T.O. side.
(277 ENGINE TYPE), PAGE 4
Chanfer
towards
inside
of crankcase
\
~!
pusher no.
polyamid nng
o
<:VAt assembly, torque to 21 Nom (15 ft-Ibs) following
illustrated sequence.
t!
no
o
,
@@Crankshaft end-play should be:
Minimum
0.20mm
(008")
Maximum
OAOmm
(016")
O
NOTE: Crankshaft end-play is adjusted only when
crankshaft and/or crankcase is replaced.