BOMBARDIER 1980 Shop Manual page 138

SECTION 03
SUB-SECTION 02, (ENGINES)
ENGINE SUPPORT &. MUFFLER
REMOVAL FROM VEHICLE
Remove or disconnect the followings (if applicable) then
lift engine out of vehicle.
S
Drive belt.
e Muffler .
• Air intake silencer tube,
c Choke cable at carburetor.
c Throttle cable at carburetor
., Fuel lines at carburetor.
O
NOTE: Secure fuel lines so that the opened ends
are higher than the fuel level In the tank.
e Disconnect negative cable (ground) from battery, then
disconnect electrical connections leading to engine.
e Console.
S
Engine mount nuts.
DISASSEMBLY & ASSEMBLY
@At assembly on crankcase, apply "Loctlte 242" or
equivalent on threads.
@Torque to 43 N'm (32 ft-Ibs),
INSTALLATION ON VEHICLE
To install engine on vehicle, inverse removal procedure.
However, pay attention to the followings
.. Check tightness of engine mount nuts.
e After throttle cable installation, check carburetor max-
Imum throttle slide opening,
.. Check pulley aliQnment,
(640 ENGINE TYPE), PAGE 2