BOMBARDIER 1980 Shop Manual page 74

SECTION 03
SUB-SECTION 02, (ENGINES)
MAGNETO
CLEANING
Clean all metal components in a non-ferrous metal
cleaner .
. . CAUTION: Clean armature and magneto using
' " only a clean cloth.
DISASSEMBLY & ASSEMBLY
0To obtain best generator coil performance. position
the armature plate on the crankcase with the
retaining
cap screws in the middle of the plate slots.
CD
Check air gap between magneto ring and trigger coil.
The gap should be
0.8 - 1.2
mm
(.031 - .047").
@@@To remove magneto. use special puller as illus-
trated. Tighten puller bolt and at same time. tap on bolt
head using a hammer to release magneto from its taper.
(354-454 ENGINE TYPES). PAGE 16
At assembly. clean crankshaft extension (taper) then
apply" Loctite 242".
0@At the re-Installation or verification of the ignition
system electric connections, all the connections must
be coated with lithium grease or dielectric grease to pre-
vent corrosion.
. . CAUTION: To prevent moisture, ensure no air is
" . trapped within the connections. Do not use silicone
sealant as contacts will corrode,
@Prior to assembly. clean threads then apply" Loctite
242" .
Torque to 80 Nom (60 ft-Ibs).