BOMBARDIER 1980 Shop Manual page 251

SECTION 05
SUB-SECTION 04 (DRIVEN PULLEY)
Round out punch marks to permit new bushing to
fit
in.
Clean the seat with Bombardier Stripper No 57.
Coat the seat with Loctite No 271 (high strength) red.
Install a new bushing (gently tap in place).
Secure bushing in place by punching the bushing shoulder
rib (as illustrated).
Reassemble pulley:
Check tension using a fish scale positioned goo with
pulley axle
(DRIVEN PULLEY). PAGE 6
Citation, Mirage
3.6 Kg (8 Ibs)
Everest. Futura, Blizzard,
Grand Prix Special, Super
Sonic, Ultra Sonic
5.9 Kg (13 Ibs)
To correct spring tension either relocate spring end in
sliding pulley half. or gradually rotate outer cam. or align
in appropriate splines.
INSTALLATION
Citation, Mirage:
0Torque to g Nom (6 ft-Ibs)
(2)
Always apply anti-seize compound (Loctite anti-seize
lubricant P / N 413 7010 00) on unpainted surface of
countershaft .
o
Make sure that the small tab of the tab lock is well
inserted in the driven pulley keyway.
Reassemble driven pulley to countershaft and install by
reversing the removal procedure.
Check pulley alignment
Everest, Futura, Blizzard, Grand Prix
Special, Super Sonic, Ultra Sonic:
Reinstall pulley. outer shims. lockwasher and bolt.
0Torque to g Nom (7 ft-Ibs).
IMPORTANT: Maximum free-play should not ex-
ceed 3 mm aU).
_ CAUTION:
@
Always apply anti-seize (Loctite
'Y
antiseize lubricant P / N 413 7010 00) compound
on countershaft before final pulley installation.