Drive Belt; Spark Arrester - BOMBARDIER outlander max series Operator's Manual

Drain the system completely and reinstall the
coolant drain plug.
Pinch hose between radiator and thermostat
housing with a large hose pincher (P/N 529
032 500) or an equivalent.
CAUTION: Do not use vise-grip pliers to
pinch hose.
V07C0AY
1. Hose pincher
Fill the radiator until the coolant comes out by
the thermostat housing hole. Install the bleed-
ing screw then remove the hose pincher.
Complete the radiator filling.
Check the level in the coolant reservoir and
refill if necessary.
Run engine at idle with the radiator cap off.
Slowly add coolant if necessary.
At this point, wait until engine reaches normal
operating temperature. Depress the throttle
lever two or three times; then add coolant if
required.
Install radiator cap. Inspect all connections for
leaks and check coolant level in the reservoir.
124
1

Drive Belt

See an authorized Bombardier ATV dealer to
check the width and the condition of drive belt.
Valve Adjustment
See an authorized Bombardier ATV dealer for
valves adjustment.
Insufficient clearance will cause loss of power
and possibly damage the valves. Excessive
clearance will cause noise.

Spark Arrester

The muffler must be periodically purged of ac-
cumulated carbon.
WARNING
Never run engine in an enclosed area. Nev-
er perform this operation immediately after
the engine has been run because exhaust
system is very hot. Make sure that there are
no combustible materials in the area. Wear
eye protection and gloves. Never stand be-
hind the vehicle while purging exhaust sys-
tem. Respect all applicable laws and regu-
lations.