BOMBARDIER 1980 Shop Manual page 91

SECTION 03
SUB-SECTION 02, (ENGINES)
ENGINE SUPPORT AND MUffLER
REMOVAL FROM VEHICLE
Disconnect or remove the followings from vehicle:
- Pulley guard and drive belt.
- Intake silencer and throttle cable.
- Fuel lines. primer and pulsation lines. fuel tank.
- Electrical wires (at engine. alternator. starter).
+
WARNING: Before disconnecting any electrical
wire in starter system, always first disconnect the
battery ground cable.
- Drain the cooling system and disconnect hoses at
engine.
- Remove engine mount nuts then lift engine from
vehicle.
DISASSEMBLY AND ASSEMBLY
@lAt assembly on crankcase, apply "Loctite 242" on
threads.
@Torque to 36 Nom (26 ft-Ibs).
@Torque to 32 Nom (23 ft-Ibs).
@Torque to 21 Nom (15 ft-Ibs).
INSTALLATION ON VEHICLE
To install engine on vehicle, inverse removal procedure.
However, pay attention to the followings:
" Check tightness of engine mount nuts.
e After throttle cable installation, check carburetor max-
imum throttle slide opening .
.. Check pulley alignment and alternator belt tension.
(444 ENGINE TYPE), PAGE 2