Drive Belt; Valve Adjustment; Spark Arrester - BOMBARDIER outlander max 800 Operator's Manual

NOTE: Do not unscrew the coolant drain plug
completely.
Remove the RH side panel.
Unscrew the bleeding screw on the top of
thermostat housing.
1. Bleeding screw
Drain the system completely and reinstall the
coolant drain plug.
Pinch hose between radiator and thermostat
housing with a large hose pincher (P/N 529
032 500) or an equivalent.
CAUTION: Do not use vise grips pliers to
pinch hose.
1. Hose pincher
130
Fill the radiator until the coolant comes out by
the thermostat housing hole. Install the bleed-
ing screw then remove the hose pincher.
Complete the radiator filling.
Check the level in the coolant reservoir and
refill if necessary.
Run engine at idle with the radiator cap off.
Slowly add coolant if necessary.
At this point, wait until engine reaches normal
operating temperature. Depress the throttle
lever two or three times; then add coolant if
required.
Install radiator cap. Inspect all connections for
leaks and check coolant level in the reservoir.

Drive belt

See an authorized Bombardier ATV dealer to
check the width and the condition of drive belt.

Valve Adjustment

See an authorized Bombardier ATV dealer for
valves adjustment.
Insufficient clearance will cause loss of power
and possibly damage the valves. Excessive
clearance will cause noise.

Spark Arrester

The muffler must be periodically purged of ac-
cumulated carbon.
WARNING
Never run engine in an enclosed area.
Never perform this operation immediately
after the engine has been run because ex-
haust system is very hot. Make sure that
there are no combustible materials in the
area. Wear eye protection and gloves.
Never stand behind the vehicle while purg-
ing exhaust system. Respect all applicable
laws and regulations.
Select a well-ventilated area and make sure
the muffler is cool.
Place transmission on PARK position.