BOMBARDIER 1980 Shop Manual page 82

SECTION 03
SUB-SECTION 02, (ENGINES)
OIL INJECTION PUMP
CLEANING
Clean all metal components in a non-ferrous metal
cleaner.
DISSASSEMBLY AND ASSEMBLY
O
NOTE: Oil pump components are not available as
single parts.
. . , @@CAUTION: On electric start models, it is
'If'
recommended to install black rubber lines
(P I N 414 2867) that will not be altered by battery
fumes.
@@At assembly, always check for clamp tightness.
@@@lTo remove retaining nut. lock gear in place using
no. 420876690 tool.
no. 420 876 690 tool
At assembly, apply a light coat of grease on gear teeth.
(377 ENGINE TYPE), PAGE 8
OIL INJECTION PUMP ADJUSTMENT
A) Prior to adjusting the pump, make sure all carburetor
adjustments are completed.
Eliminate the throttle cable free play by pressing the
throttle lever until a light resistance is felt, then hold
In
place. (A small rubber band can be used). The
aligning marks on the pump casting and on the lever
must align. If not, loosen the adluster nut and adlust
accordingly .
Retighten the adluster nut.
Adjuster
nut
Bleeder
~~.
~~.~
B) All oil lines should be full of oil. If required, bleed
the main oil line (between tank and pump) by loosening
the bleeder screw until all air has escaped from the
line.
Make sure the tank is sufficiently filled.
Check the small oil lines (between pump and intake
manifold). If required, fill the lines by running the
engine at idle speed while holding the pump lever
in fully open position.