BOMBARDIER 1980 Shop Manual page 182

SECTION 03
SUB-SECTION 06, (REWIND STARTER)
000
To
remove
rope from rewind starter mechanism,
fully extend rope and hold rope sheave
In
position, Then
using a pointed tool, disengage key clamp and pull rope
free,
~
u
u
~""~~
~
To install rope, proceed as follow
- Rotate sheave counter-clockwise six (6) turns to
achieve correct recoil tension. Hold in position.
- While holding sheave under tenSion, rotate sheave until
the starter housing orifice and sheave orifice align.
- Insert rope through both orifices until rope is visible
in the key clamp housing.
- Position the key clamp in ItS housing then push in
to lock the rope,
0000
At assembly, position spring outer end into
spring guide notch then wind the spring clockwise Into
gUide .
•
WARNING: Since the spring is tightly wound
inside the guide it may fly out when the guide
is manipulated, Always handle with care,
Before installing spring ass'y into starter hOUSing, lubri-
cate spring with light machine oil. Also apply low temper-
ature grease on housing shaft base.
Position spring assembly into starter hOUSing as illustrat-
ed, then place rop sheave into starter housing making
sure that the sheave hub notch engages In the spring
hook.
(REWIND STARTER), PAGE 2
Hub notch
0@
Plastic rope sheaves and metal rope sheaves are
Interchangeable. However it is recommended to use the
appropriate screws with plastic rope sheaves.
@@@@Position pawls, springs and spring stops on
plvotmg arm as illustrated.
Spring stop
~~
Chamfer
Chamfer
Install and secure pivoting arm assembly within rope
sheave hub, making sure that the assembly moves clock-
wise when the rope sheave is turned counterclockwise.
Sheave rotation
t
Reinstall pawl gUide onto sheave (It may be necessary
to pull on starter rope to ease guide installation).
INSTALLATION
Reinstall rewind starter on engine and secure with pre-
viously removed bolts and washers.
O
NOTE: If applicable, connect hood retalOlng cable
to one (1) of the starter hOUSing bolts.