When reinstalling belt guard, position its cut-away toward front of
snowmobile. Refer to decal in belt guard.
Place belt guard slots over tabs first, then snap the other end in re-
tainer.
A32C06A
TYPICAL
1. Slots
Drive Belt Removal/Installation
Remove tether cord cap before performing any maintenance
or adjustment, unless otherwise specified. Vehicle must be
parked in a safe place, away from the trail.
Removal
NOTE: Removal and installation of drive belt is easier when driven
pulley is held with brake so that it can not rotate. Apply parking brake,
for this purpose.
Remove tether cord cap. Open engine compartment and remove belt
guard.
1
WARNING
131