BOMBARDIER 1980 Shop Manual page 306

INSTALLATION
If the drive axle to be installed is a new component and
the vehicle is equipped with a speedometer, a speedome-
ter drive insert must be installed into the axle end. Ensure
that insert is flush with end of axle.
Position drive axle assembly into location. Install shim
between bearing and lower chaincase sprocket. Install
end bearing housing.
Install chaincase and position seals, making sure that
a gap of approximately 2 mm
(1/16")
eXists between
end of bearing housing and each seal.
Bearing
.~
2 mm
&Z;p~apr
~
011
seal
SECTION 06
SUB-SECTION 04 (DRIVE AXLE)
Everest 500/E, Futura 500/E
Everest LC, Futura LC
Blizzard 5500, Grand Prix Special
Blizzard 7500, Super Sonic
Blizzard 9500, Ultra Sonic
install new lock tabs,
Install the screws and torque to 9.5 N
o
m,(7 ft-Ibs).
Bend the tab locks.
. . , CAUTION: Lock tabs should be replaced if bent
" more than twice. If in doubt, replace.
Reinstall the chaincase cover.
Refill with chaincase oil.
Install the suspension. Apply track tension and carry out
track alignment procedure.
(DRIVE AXLE). PAGE 5