BOMBARDIER 1980 Shop Manual page 308

SECTION 06
SUB-SECTION 05, (TRACK)
TRACK INSERT INSTALLATION
Using W. 419 0027 Tool.
Tilt vehicle on its side to expose the track notches then
place insert into position.
Place the track insert installer into track notches and
pas'ltion male j'lg on top of track insert.
Tighten Installer bolt until track insert IS locked in place.
IJ=\J
~
Female J'9
~
[J=\]
(TRACK). PAGE 2
Using W. 529 0026 Tool.
For narrow
'nserts~
-(
For wide Inserts
Place Inserts into position and. with tool being under the
inserts, tap them over the track using a hammer.
;-"'65
i.e.,)
---'.c..
:oJ
Q=~U=
I"";;L
~
Tool
I
i
--0
OZdl
1 . .
,,~
INSTALLATION
Raise and block rear of vehicle off the ground. Position
track beneath the vehicle frame tunnel.
O
NOTE: When installing the track. ensure the right
angle of bearing surface of the track rib is facing
the front of vehicle.
Front Rear
/
- -
/
Ground level
lL'
U
-
- -
-
-
-
- -
-
-
- -
- --
Install drive axle.
If applicable. install rear axle. Install suspension system.
Carry out track tension and alignment procedure.
Track tension & alignment
Track tension and alignment are inter-related. Do not
adjust one without checking the other. Track tension
procedure must be carried out prior to track alignment.