BOMBARDIER 1980 Shop Manual page 106

SECTION 03
SUB-SECTION 02, (ENGINES)
ENGINE SUPPORT & MUFFLER
REMOVAL FROM VEHICLE
Disconnect or remove the followings from vehicle:
- Pulley guard and drive belt
- Air silencer and throttle cable
- Fuel lines, primer, pulsation and oil injection lines
- Muffler and rewind starter
- Electric wires
•
WARNING: Always disconnect ground cable first,
before any other wire of the starting system.
- Drain the cooling system and disconnect hoses at
engine
- Rotary valve oil reservoir
- Disconnect rewind starter at engine
DISASSEMBLY & ASSEMBLY
o
Torque to 36 N'm (26 ft-Ibs).
@Torque to 22 N'm (16 ft-Ibs).
INSTALLATION ON VEHICLE
To install engine on vehicle, reverse removal procedure.
However. pay attention to the followings:
.. Check tightness of engine mount nuts.
e After throttle cable installation, check carburetor maxi-
mum throttle slide opening and oil pump adjustment.
" Check pulley alignment.
(464 ENGINE TYPE). PAGE 2