BOMBARDIER 1980 Shop Manual page 231

Install governor cup correctly as per illustration making
sure that the rollers are sliding on their ramp.
t{Z)-
y
Position retaining bolt then lube torque to 61 Nom (45
ft-Ibs) .
+
WARNING: Shim(s) @ is(are) used to obtain a
neutral fonction of the drive pulley when engine
is idling. Proceed as follows when retaining bolt is
torqued:
With a new dllve belt installed. you should be able to
Insert a minimum of 0.80 mm (.030") thick feeler gauge
on each side of the dllve belt simultaneously when pushing
dllve belt to Sit on beallng.
080
mm
feeler
gauge
SECTION 05
SUB-SECTION 03, (DRIVE PULLEY)
080 mm
feeler
gauge
Shlm@located between governor cup and dllve pulley
shaft will help you to obtain correct adjustment. Use not
more then two (2) shims.
(DRIVE PULLEY). PAGE 3