BOMBARDIER 1980 Shop Manual page 256

INSTALLATION
Position drive shaft of assembled driven pulley so that
retainer washers align with slots of gearbox casing.
Retainer washer
Connect drive chain using a connecting link.
The locking clip should be installed oppositely to driven
pulley.
Position gear change fork in gearbox cover so that it aligns
with slot of sliding gear in gear housing.
o
Gear
change fork
o
SECTION 05
SUB-SECTION 04 (DRIVEN PULLEY)
Sliding
gear slot
Apply a thin coat of "Loctite crankcase sealant", or
equivalent, on contact surface of gearbox casing.
Install gearbox cover and secure with eight nuts. Torque
nuts to 27 N'm (20 ft-Ibs) in the following sequence:
o
6
7
o.J4
31
0
8
2 5
o
Install gearbox rod and adjust. (See Section 05-07).
Install steering column.
Install drive belt and exhaust manifold,
Install brake assembly and bracket. Install roll pin securing
disc to shaft,
Adjust chain tension. Check gearbox oil level.
Check pulley alignment and install pulley guard,
(DRIVEN PULLEY), PAGE 11