BOMBARDIER 1980 Shop Manual page 301

SECTION 06
SUB-SECTION 03, (REAR AXLE)
Secure idler wheel and flanges uSing bolts and nuts
tightened in the following sequence to 3.5 Nom (3 ft-Ibs).
®®Tightening torques for sprockets are 3.5 Nom (3
ft-Ibs).
6
5
® Always pull or push the bearing by inner race. Install
bearing with shield facing the sprocket.
Bearing
shield
® When assembling. always position a new seal. When
inserting seals Into link plate. seal lip must sit correctly
in groove of link plate. After lubricating the rear axle.
ensure that seals remain in position.
(REAR AXLEI. PAGE 2
INSTALLATION
With rear of vehicle off the ground. position the rear axle
within the track.
Install sleeves. hardener washers and eye bolts.
Partially screw-in the track adjuster bolts.
Hook the link plate springs. If applicable. hook springs
into middle position of 3 position anchors.
Install retainer washers and partially tighten the link plate
spring lock nuts.
Carry out track tension and alignment.