BOMBARDIER 1980 Shop Manual page 200

3. LIGHTING COILS OUTPUT (277
ENGINE TYPE)
O
NOTE: On the engine type covered by this test an
additional lighting coil is connected in parallel with
the main lighting coil. In this case. the parallel connection
must be broken off as each coli IS to be tested individually.
1. Disconnect wiring harness junction block at engine.
2. Connect tester leads as Illustrated using two (2)
harness adaptors.
large coli: yellow and yellow/black wires
small coil: green and green/black (or ground) wires.
3.
Set tester dial and switch as follows:
Engine type Switch position
Dial
277
LOW
85
4. With ignition key to OFF position. crank engine.
A. Indicator lamp lights: Coil output is up to specifi-
cations. Repeat test at least three (3) times to verify
reading and consistency.
B. Indicator lamp does not light: Coil is faulty.
SECTION 04
SUB-SECTION 02, (ELECTRICAL TESTS)
(BOMBARDIER IGNITION TESTER). PAGE 5