BOMBARDIER 1980 Shop Manual page 203

SECTION 04
SUB-SECTION 02, (ELECTRICAL TESTS)
8.
LIGHTING COIL OUTPUT
1. Disconnect wiring harness junction block at engine.
2. Connect tester leads as illustrated uSing two (2)
harness adaptors.
3. Set tester dial and sWitch as follows:
Engine type
Switch
positio~
Dial
354. 454
LOW
80
4. Crank engine.
A. Indicator lamp lights: lighting coil output IS up to
specifications. Repeat test at least three (3) times to
verify reading and consistency.
B. Indicator lamp does not light: Lighting coil IS faulty.
(BOMBARDIER IGNITION TESTER). PAGE 8