Drive Belt - BOMBARDIER 2006 outlander max 400 Operator's Manual

1
V07C09Y
1. Bleeding screw
2. Engine temperature sensor
Drain the system completely and reinstall the
coolant drain plug.
Pinch hose between radiator and thermostat
housing with a large hose pincher (P/N 529
032 500) or an equivalent.
130
CAUTION: Do not use vise-grip pliers to
pinch hose.
2
V07C0AY
1. Hose pincher
Fill the radiator until the coolant comes out by
the thermostat housing hole. Install the bleed-
ing screw then remove the hose pincher.
Complete the radiator filling.
Check the level in the coolant reservoir and
refill if necessary.
Run engine at idle with the radiator cap off.
Slowly add coolant if necessary.
At this point, wait until engine reaches normal
operating temperature. Depress the throttle
lever two or three times; then add coolant if
required.
Install radiator cap. Inspect all connections for
leaks and check coolant level in the reservoir.

Drive Belt

See an authorized Bombardier ATV dealer to
check the width and the condition of drive belt.
Valve Adjustment
See an authorized Bombardier ATV dealer for
valves adjustment.
Insufficient clearance will cause loss of power
and possibly damage the valves. Excessive
clearance will cause noise.
1