BOMBARDIER 1980 Shop Manual page 250

(
REMOVAL
- Loosen upper footrest bolt and remove lower one.
- Pullout the side of the bottom plate. Remove pulley
assembly
"'l 17
Always apply anti-seize
_
~\
compound betoee tina I assembly
Pull out the side of
bottom plate
o
o
0
Loosen upper footrest bolt
\\~~~~'
\
Remove lower footrest bolt
. . CAUTION: Always apply anti-seize compound on
Y
the countershaft before final pulley installation
(Loctite anti-seize lubricant PIN 413 701000).
DISASSEMBLY & ASSEMBLY
All models equipped with a countershaft drive system.
•
WARNING: The driven pulley cam is spring loa-
ded. Hold in place when removing the circlip.
SECTION 05
SUB-SECTION 04 (DRIVEN PULLEY)
DRIVEN PULLEY BUSHING
REPLACEMENT
To replace the outer and inner bushings of the floating
type driven pulley. proceed as follows:
Remove and disassemble driven pulley assembly.
Outer bushing:
Remove the three (3) screws on sliding half.
Remove the bushing with a pin punch. as illustrated.
Clean the bushing seat with Bombardier Stripper No 57.
Coat the seat with Loctite No 271 (high strength) red.
Install the new bushing (gently tap in place).
Reinstall screws. using Loctite 242 (medium strength)
blue.
Reassemble pulley .
Inner bushing:
Remove the bushing with a pin punch. as Illustrated.
(DRIVEN PULLEY). PAGE 5