BOMBARDIER 1980 Shop Manual page 41

SECTION 03
SUB-SECTION 02 (ENGINES)
IENGINIE SUPPORT AND MUffLER
REMOVAL FROM VEHICLE
Remove or disconnect the followings then lift engine from
vehicle .
• Pulley guard.
" Drive belt.
co Muffler.
.. Choke knob.
It
Decompressor .
.. Throttle calbe.
e Fuel lines .
• E!ectrical connector.
.. Separate steering column support at upper column.
11&
Engine mount nuts.
DISASSEMBLY & ASSEMBLY
@Torque to 31 Nom (23 ft-Ibs).
@Torque to 35 Nom (26 ft-Ibs).
@Torque to 22 Nom (16 ft-Ibs).
INSTALLATION ON VEHICLE
To install engine on vehicle, inverse removal procedure.
However, pay attention to the followings
.. Check tightness of engine mount nuts, and drive pulley
bolt.
a After throttle cable installation, check maximum throt-
tle slide opening
a Check pulley alignment.
(247 ENGINE TYPE). PAGE 2