BOMBARDIER 1980 Shop Manual page 219

SECTION 05
SUB-SECTION 01 (PULLEY GUARD)
REMOVAL
Pullout hair pin and remove driven pulley guard. Pull
on spring to disengage pin from frame bracket. in order
to disengage drive pulley guard.
+
WARNING: Never start engine until pulley guard
is well installed.
8The length of uncompressed pin spring should not be
less than 47 mm (1
k").
@An uncompressed front guard spring should not be
less than 20 mm (13/16"). When assembling adjust
length to 17 mm (11/16").
~
1"-17mm
INSPECTION
®®
Check condition of call pin. If damaged, replace.
INSTALLATION
Prior to installation, ensure that pulley guard and frame
bracket are 90
0
with frame.
No free-play
-
~
~
- - - -
90' 90'
+
WARNING: No lateral free-play should exist be-
tween drive pulley guard and frame bracket,
Slide pulley guard Into bracket,
Pullan lower spring bolt. engage Pin Into frame bracket
and install hair pin.
Install driven pulley guard.
(PULLEY GUARD), PAGE 2