BOMBARDIER 1980 Shop Manual page 290

SECTION 06
SUB-SECTION 01, (BOGIE WHEELS)
REMOVAL
Raise and block rear of vehicle off the ground.
Release track tension by unlocking the link plate springs
using link plate lever (See Tool Section).
Middle pOSition
Lmk plate
spring
Link plate
spnng lever
Starting at center bogie wheel set. remove bolts and lock
washers securing cross shaft to frame.
O
NOTE: To prevent the cross shaft from rotating
within the cross support. wedge a screwdriver blade
between the cross shaft and cross support.
Cross suppon
~
Remove bogie wheel set.
O
NOTE: Since spring diameter may vary depending
upon actual installation location,
it
is important to
identify the installation of each bogie wheel set. Observe
this position when reinstalling sets.
Repeat operation for remaining bogie wheel sets.
(BOGIE WHEELS), PAGE 2
DISASSEMBLY & ASSEMBLY
(2)
Heat wheel support anchor before attempting to open
or close anchor.
®
Clean, then lubricate cross shaft With low temperature
grease before installation.
®
Always pull or push bearrng by Inner race. When
Installing bearing on wheel support, position bearing
shield towards inner flange, then press down until bearrng
IS sitting flush With support end.
0@
Bogie wheels are factory riveted, When separation
IS
necessary, remove rivets securing wheel tire and flanges
by usrng a 3/16" dia. Secure flanges and tire using
bolts and nuts tighten rn the following sequence to 38
Nom (28 ft-Ibs),
6
5
Torque sequence