BOMBARDIER 1980 Shop Manual page 198

Battery replacement
1. Remove the four (4) screws securing cover to case.
2. Carefully lift cover.
3. Replace batteries with size ··C· Alkaline battenes. Be
sure to observe polarity markings on battery holder
or lamp will not light.
4. Carefully Install cover on case being certain that no
wires are pinched between cover and case. Secure
cover.
O NOTE: Weak batteries will not impair tester opera-
tion or calibration. The light will glow dim.
The ignition tester may give false readings if the rivets
on the back cover come in contact with metal.
Indicator knob alignment
Check indicator knob alignment by turning knob fully
clockwise. The white mark on the knob must align with
no. 100 on the scale. If the marks does not line up with
the no. 100. loosen the knob set screw. line the mark
on the knob with no. 100. and tighten the set screw.
Recheck alignment.
O
NOTE: If after adjustment. the knob is turned fully
counter-clockwise and it does not exactly align with
the 0, it is of no consequence.
SECTION 04
SUB-SECTION 02, (ELECTRICAL TESTS)
TESTS INDEX
ROTAX ONE CYLINDER
BREAKER POINTS ENGINE
1. Generator coil output.
2. lighting cOils output. (247 engine type)
3. lighting coils output. (277 engine type)
ROTAX TWO CYLINDER
BREAKER POINTS ENGINE
4. Generator coil output.
5. lighting coils output.
ROTAX TWO CYLINDER
ELECTRONIC IGNITION ENGINE
6. Generator coil output.
7. Tngger coil output.
8. Lighting coil output.
(BOMBARDIER IGNITION TESTERI. PAGE 3