BOMBARDIER 1980 Shop Manual page 285

O
NOTE: A gap of approximately 1.6 mm (1/ 16")
should exist between the end of bearing housing
and 011 seal.
Beanng ~1.6mm
011 seal
~.'
: /.11
Sprmg
Install shifter mechanism and adjust (see section 02-08,
Shifter mechanism).
Install brake and driven pulley support.
Apply chain tension by rotating tensioner axle
®
to obtain
6 mm (t") maximum chain free-play.
Pour .625 mL (22 Imp. ounces) of Bombardier chaincase
oil into gearbox.
Install engine and carry out pulley alignment.
Install suspension systems. Proceed with track tension
and alignment.
Install drive belt and pulley gard.
Install engine compartment access plates, seats and seat
backs.
SECTION 05
SUB-SECTION 08, (GEARBOX)
(GEARBOX WITH FORWARD
&
REVERSE), PAGE 7