BOMBARDIER 1980 Shop Manual page 335

HEADLAMP BEAM AIMING
Place the vehicle on a flat surface 7.6 m (25') from
a wall or screen.
TOP VIEW
Headlamp horizontal W II
~ 'T~m_~'
.. R
7.6 m (25
ft)
).
SIDE VIEW Ground
With the suspension correctly adjusted. the rider seated
on the vehicle and the high beam ON (engine must be
running on manual start models). check that the center
of the high intensity zone of the high beam is 50 mm
(2") below the horizontal line of the headlamp height.
Headlamp
horizontal
center line
Center line
of intensity zone
Intensity zone
of
high
beam
(projected on the wall)
-----------r
50 mm
To adjust. on vehicles so equipped. remove the headlamp
chrome ring, turn the upper or lower adjusting screws
to obtain the desired beam position.
BULB REPLACEMENT
If headlamp is burnt. tilt cab. unplug the connector from
the headlamp. Remove the rubber boot and unfasten the
bulb retainer clips. Detach the bulb and replace. If the
tailling bulb is burnt. expose the bulb by removing red
plastic lens. To remove. unscrew the two (2) Phillips head
screws. Verify all lights after replacement.
SECTION 08
SUB-SECTION 01, (HOOD)
HOOD MAINTENANCE
Clean the vehicle thoroughly. removing all dirt and grease
accumulation .
. . , CAUTION: Plastic alloy components such as fuel
Y
tank, windshield, hood, etc. can be cleaned using
mild detergents or isopropyl alcohol. Do not use strong
soaps, degreasing solvents, abrasive cleaners, paint
thinners, etc.
Inspect hood and repair damage. Repair kits are available
at your authorized dealer.
O
NOTE: Apply wax on glossy finish of hood only.
Protect the vehicle with a cover to prevent dust
accumulation during storage.
. . , CAUTION: If for some reason the snowmobile has
' " to be stored outside
it
is necessary to cover
it
with
an opaque tarpaulin. This caution will prevent the sun
rays affecting the plastic components and the vehicle
finish.
DECAL
To remove a decal. pull it off.
Clean the surface.
Apply liquid soap on the new decal. Position the decal
and pass a sponge over it to remove air bubbles and
water. Allow to air dry.
(HOOD). PAGE 11