BOMBARDIER 1980 Shop Manual page 336

SECTION 08
SUB-SECTION 01, (HOOD)
WINDSHIELD INSTALLATION
Elan, Spirit
Citation 3500, Mirage I
Citation 4500/E, Mirage IIIE
Citation SS, Mirage Special
- Peel off the protective film from the windshield.
- Position the windshield on the hood then push it down
until the tabs are fully inserted into the hood slots.
Lock the windshield tabs in position using the" 0"
rings supplied in the kit.
- Install the windshield trim.
Everest 500
IE,
Futura 500/ E
Everest LC, Futura LC
- Peel of protective film from windshield.
- Position windshield on hood then push down until tabs
are fully inserted into hood slots. Lock windshield tabs
in position using the "0" rings supplied in kit.
- Using the windshield holes as a guide, drill
Ir"
dia.
holes through the hood. Install the four (4) screws.
- Install the windshield trim.
Grand Prix Special, Blizzard 5500
Super Sonic, Blizzard 7500
Ultra Sonic, Blizzard 9500
- Peel off protective film from the new windshield.
- Position windshield on hood then push until tabs are
fully inserted into slots. Lock windshield tabs in position
using the "0" rings supplied in kit.
- Using the windshield holes as a guide, drill
7132"
dia.
holes through hood. Install retaining bolts and push
nuts.
- Install windshield trim
(HOOD), PAGE 12
Elite
- Align the windshield in position (in order to have the
windshield deflector pleat on each side in line with
the body side).
- Mark the body, and drill 17/64" holes. Secure the
windshield in place.
- Install windshield trim on outer edge.
- Install the hood stopper in place by drilling a
Ir"
hole
in the center of the windshield at exactly 23 mm (9")
from bottom edge of windshield and push the hood
stopper in place.
Alpine
- Peel off protective film from the new windshield.
- Position windshield on hood then push until tabs are
fully inserted into slots. Lock windshield tabs in position
using the eleven (11) "0" rings supplied in kit (install
two (2) "0" rings on outer tabs).
"0"
ring
(