Drive Belt; Valve Adjustment; Spark Arrester - BOMBARDIER rally 200 Operator's Manual

Pinch hose between radiator and thermostat
housing with a large hose pincher (P/N 529
032 500).
V06C07Y
Lift the front of the vehicle high enough to
have front wheels off the ground.
Fill radiator until the coolant comes out by the
temperature sensor hole. Install the bleeding
screw then remove the hose pincher.
NOTE: If no coolant comes out by the bleed-
ing hole, squeeze the lower radiator hose
several times until coolant comes out.
Complete the radiator filling.
Check the level in the coolant reservoir and
refill if necessary.
Run engine at idle with the radiator cap off.
Slowly add additional coolant if necessary.
At this point, wait until engine reaches normal
operating temperature. Depress the throttle
lever two or three times; then add coolant if
required.
Install radiator cap. Inspect all connections for
leaks and check coolant level in the reservoir.
Check if the carburetor heater is warm. If not,
redo the bleeding procedure.
Reinstall front fascia.

Drive Belt

See an authorized Bombardier ATV dealer to
inspect and/or replace the drive belt.

Valve Adjustment

See an authorized Bombardier ATV dealer for
valves adjustment.
Insufficient clearance will cause loss of power
and possibly damage the valves. Excessive
clearance will cause noise.

Spark Arrester

The muffler must be periodically purged of ac-
cumulated carbon.
WARNING
Never perform this operation immediately
after the engine has been run because ex-
haust system is very hot. Wear eye protec-
tion and gloves. Respect all applicable
laws and regulations.
Place transmission on NEUTRAL position
and apply parking brake.
Remove the spark arrester from the muffler
2
1
V06C2HY
1. Spark arrester
2. Muffler
101