Selecting The Printout Function - Sartorius Factory Series Operating Instructions Manual

Selecting the Printout Function

(PRINTOUT)
Purpose
This menu item enables you to
configure the printout to meet your
individual requirements by selecting
predefined menu parameters in the
Setup menu. Printouts of weights and
other measured or calculated values
and IDs enable you to document your
data. You can select the particular
data you wish to print. To prevent
changes to your settings, you can
block access to the menu by
assigning a password.
Features
The device parameters are combined
in the following groups (1st menu
level):
– Application-defined output
– Configured Printout
– FlexPrint
– Automatic output of displayed
values
– Output to interface port
– Line format
– ISO/GLP/GMP printout
– Identification (identifier)
– Factory settings – printout only
Factory Settings
Parameters: The factory settings are
identified by the symbol "ο" in the list
on the next page.
52
Preparation
Display available printout parameters
§ Select the Setup menu: press M
> SETUP is displayed:
§ Select "Printout": use the q and O
soft keys
If no password has been assigned,
anyone can access the printout
parameters in the Setup menu
If a password has already been
assigned:
> The password prompt is displayed
$ If access is blocked by a password:
enter the password using the nume-
ric and/or alphabetic keys
$ If the last character of the password
is a letter: conclude input by
pressing the a key
§ Press l to confirm the password
> Printout parameters are now dis-
played:
$ To select the next group: press the
q soft key (down arrow)
$ To select the previous item of a
group: press the Q soft key (up
arrow)
$ To select the next sub-item within a
group: press the O soft key (right
arrow)
$ To select the previous group: press
the o soft key (left arrow)
$ To confirm: press the l soft key
Extra Functions
§ Exit the Setup menu: press the oo
soft key
> Restart your application
§ Print parameter settings:
– When the printout parameters are
displayed, press p
> Printout (Example)
SETUP
PRINTOUT
--------------------
Application defined
Stability paramete
With Stability
Print on request t
Off
Auto print upon in
All values
Configured printou
Indiv.: Printout
Comp.: Printout
Total: Printout
FlexPrint
Automatic Output of
Stability paramet
Without stabili
Stop auto print
Not possible
Time-dependent aut
1 display update
Output to interface
Serial communicat:
Application-defined
output
Line format
For other apps/GLP
(22 characters)
ISO/GLP/GMP printou
Identification
Lot (L ID):
ID1:
etc.
Off
Off
ID1