Sartorius Factory Series Operating Instructions Manual page 99

Preparation
§ Turn on the scale: Press e
> Sartorius logo is displayed
§ Select the "Calculation" application program in the Setup menu: Press M
FC Models:
§ Select the Application menu:
§ Select
Application 1
FCA Models:
§ Select
Application parameters
then the O soft key once
§ Select
Application 1 (basic settings)
§ Select
Calculation
§ Confirm
Calculation
§ Select and confirm:
–
Decimal places in calculated result
or
None
1 decimal place
2 decimal places
3 decimal places
4 decimal places
5 decimal places
6 decimal places
see also the "Application Menu (Overview)" in the chapter entitled
"Configuring the Scale"
§ Save settings and exit the Setup menu: Press oo soft key
soft key
App
: O soft key
: press the q soft key 2 x,
: Q or q soft key repeatedly
: O soft key
or
or
or
or
or
Operating the Scale
Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during
– printing,
you can also access the following
functions from this application:
Calibration/Adjustment
: press the O soft key
§ Press the
> See "Calibration/Adjustment"
Toggling to the Next Application
:
§ Press D
> See the section on the
Setup (setting parameters)
§ Press M
> See "Configuring the Scale"
Turning Off the Scale
§ Press e
> The scale shuts off
> The display goes blank
alphanumeric input),
soft key
isoTST
for further instructions
corresponding application pro-
gram for further instructions
for further instructions
99