Selecting The Printout Function - Sartorius FC06BBE-S Operating Instructions Manual

Selecting the Printout Function (

Purpose
This menu item enables you to
configure the printout to meet your
individual requirements by selecting
predefined menu parameters in the
Setup menu. Printouts of weights and
other measured or calculated values and
IDs enable you to document your data.
You can select the particular data you
wish to print. To prevent changes to
your settings, you can block access to
the menu by assigning a password.
Features
The device parameters are combined in
the following groups (1st menu level):
– Application-defined output
– Configured Printout
– FlexPrint
– Automatic output of displayed values
– Output to interface port
– Line format
– ISO/GMP printout
– Identification (identifier)
– Factory settings – printout only
Factory Settings
Parameters: The factory settings are
identified by the symbol "ο" in the list
on the next page.
30
PRINTOUT
Preparation
Display available printout parameters
§ Select the Setup menu: press H
> SETUP is displayed:
§ Select "Printout:" use the
q
soft keys
If no password has been assigned,
anyone can access the printout
parameters in the Setup menu
If a password has already been
assigned:
> The password prompt is displayed
$ If access is blocked by a password: enter
the password using the numeric and/or
alphabetic keys
$ If the last character of the password is
a letter: conclude input by pressing the
a key
§ Press
to confirm the password
l
> Printout parameters are now displayed:
$ To select the next group:
press the q soft key (down arrow)
$ To select the previous item of a group:
press the soft key (up arrow)
Q
$ To select the next sub-item within
a group: press the soft key
O
(right arrow)
$ To select the previous group:
press the soft key (left arrow)
o
$ To confirm: press the
soft key
l
)
Extra Functions
§ Exit the Setup menu:
press the
oo
> Restart your application
§ Print parameter settings:
– When the printout parameters
are displayed, press p
> Printout (Example)
and
O
SETUP
PRINTOUT
--------------------
Application defined
Stability paramete
With Stability
Print on request t
Auto print upon in
Configured printou
Indiv.: Printout
Comp.: Printout
Total: Printout
FlexPrint
Automatic Output of
Stability paramet
Without stabili
Stop auto print
Time-dependent aut
1 display update
Output to interface
Serial communicat:
Application-defined
output
Line format
For other apps/GLP
(22 characters)
ISO/GLP/GMP printou
Identification
Lot (L ID):
ID1:
etc.
soft key
Off
All values
Off
Not possible
Off
ID1