Individual Identification; Codes (Id) - Sartorius Factory Series Operating Instructions Manual

Individual Identification Codes
(ID)
Purpose
With this function, you can assign
IDs to values for documentation and
printouts.
You can use this function in
combination with any program from
Application 1 (such as counting,
weighing in percent), one from Appli-
cation 2 (checkweighing,
time-controlled functions) and one
from Application 3 (totalizing,
formulation, statistics) as well as with
the other extra functions.
Features
– Store up to 4 IDs; these can be
stored, changed or deleted
individually.
– Each ID consists of a name and a
value; both can be defined by the
user.
– ID designations are configured as
follows: Setup: Printout: Identificati-
on codes
– Each ID code can have up to 20
characters; when you enter the
value later, however, no more than
15 characters of this ID are
displayed.
136
– The ID values are entered while the
application program is active;
press the soft key to toggle to
ID
the ID input mode.
– Each ID value can have up to 20
characters.
– Access 1 of the 4 IDs directly using
the numeric keys. The other three
can only be accessed by pressing
the soft key to toggle to the ID
ID
input mode.
– You can assign this function to the
fourth or fifth soft key (from the
right); i.e., F4 or F5.
– You can configure when the ID will
be included on the printout (see
"Preparation" on the next page).
– You can configure the position of
IDs on the individual or total
printout.
– The ID code is printed flush left; the
value flush right. If the name and
value together are too long for one
line, the data is printed on two
lines.
– Optional configuration in the Setup
menu to delete a single character
when entering an identification
code by pressing c. Setup:
Device parameters: Keys: CF
function for input: Delete last
character
– Press the soft key to
Delete
delete an ID
Factory Settings of the ID Names
ID1:
ID1
ID2:
ID2
ID3:
ID3
ID4:
ID4
Factory Settings for ID Codes
No values set
Factory Settings
Printout:
Each time the print key
is pressed
Soft Key Functions
Toggle to "Identification
ID
codes" menu
Delete input of selected ID
Delete
Printout of ID Codes
Up to 4 (stored) identification codes
are printed out.
ID1 Lot no. 1234
ID2 Daimler/Chrysler
ID3 Screws M4x6
ID4 Jack Smith
ID1: Identification 1 (ID 1)
ID2: Identification 2 (ID 2)
ID3: Identification 3 (ID 3)
ID4: Identification 4 (ID 4)