Intended Use; Getting Started; Unpacking And Equipment Supplied; Selecting A Setup Location - Sartorius PMA.Evolution Installation Instructions Manual

Lay the cables where they pose no risk of
causing someone to trip.
Never close a paint can using a hammer while it
is still on the weighing pan.
When closing, place the paint can on a firm,
stable surface.
Observe the additional safety and danger information in the
following chapters.

2.3 Intended Use

This scale is only intended for mixing colors and paints. The
scale is connected to the ex-link converter installed outside of
the potentially explosive area only using the supplied link
cable. The scale is used in Zone 1 potentially explosive areas.
Appropriate containers must be used for each type of
material.
The scale can be operated via the keypad as a stand-alone
device or using application software (such as a paint-mixing
program from a paint manufacturer) installed on a connected
PC. The scale is connected to the ex-link converter installed
outside of the potentially explosive area via a USB cable.

3 Getting Started

The scale must be disconnected from the power
supply for all assembly work.

3.1 Unpacking and Equipment Supplied

t
Open the packaging, making sure to remove all parts
carefully.
t
After unpacking the device, check it immediately for any
external damage.
t
If you detect any damage, proceed as directed in
Chapter "4 Care and Maintenance," page 8.
t
Save the box and all parts of the packaging for any future
transport.
All cables should be unplugged when transporting.
The following parts are included in the equipment supplied:
Model
Large weighing pan: d 233 mm
Small weighing pan: d 180 mm
USB cable
Ex-link converter
Link cable from converter to scale
Installation instructions
Evolution HD
x –
– x
x x
x x
x x
x x

3.2 Selecting a Setup Location

Select the right setup location:
− Set up the device on a stable, even surface that is not
exposed to vibrations.
− Maintain free access to the device at all times.
Choose a location that is not subject to the following negative
influences:
− Heat (heater or direct sunlight)
− Drafts from open windows, A/C systems, and doors
− Extreme vibrations during weighing
− Heavy traffic areas (personnel)
− Extremely high humidity
− Electromagnetic fields
− Extremely dry air
Acclimatization
Condensation from humidity can form on the surfaces of a
cold device when it is brought into a substantially warmer
area. You should therefore let a device that has been
disconnected from its power source acclimatize for
approximately 2 hours before reconnecting it to the
supply voltage.

3.3 Installing the Scale

Inserting the Weighing Pan
t

3.4 Power Supply

The scale is connected to the power supply via a
PC/notebook or using the optional AC adapter
YPS06-USB (see Chapter "6 Accessories,"
page 9), which is supplied with mains
adapters for use in various different countries.
Power supply via the AC adapter is only
required:
− When no PC or notebook is available.
− In exceptional cases, when the output voltage
of the USB interface of the PC or notebook is
not high enough.
AC adapter assembly is described in the following.
3.4.1 AC Adapter Assembly
Using the wrong mains adapter may cause
fatal electric shock and damage the
equipment.
Never plug the mains adapter into the socket
when it is disconnected from the AC adapter
(danger of electrical shock).
EVO1X | LAB1X Installation Instructions
English
Place the weighing pan onto the
scale from above.
5