Sartorius Factory Series Operating Instructions Manual page 104

Preparation
Turn on the scale: press e
> The Sartorius logo is displayed; a self-test is performed
Select the "Differential weighing" application in the Setup menu: press M
FC Models:
§ Select the Application menu:
§ Select
Application 2
FCA Models:
Select the
Application parameters
then the O soft key once
Select
Application 1 (basic settings)
Select
Differential weighing
repeatedly, if necessary
Confirm
Differential weighing
Differential Weighing sequence
weighing
Tare weighing
Result with
decimal point
Autosave
values
Minimum load
for autosave
Save statistics
Generate printout
Include sample ID
in text line
Wg. seq. key
Clear sample after
unload + res + ind. wgh.
Last residual weight
(ashing)
104
soft key
App
: Press the q soft key and then the O soft key
: press the q soft key 2 x,
: press the O soft key
: press the Q or q soft key,
: press the O soft key
1) Individual weighing
Consecutive individual weighing
o Combined weighing
Serial weighing
No
o Yes
None
1 decimal place
o 2 decimal places
3 decimal places
4 decimal places
5 decimal places
6 decimal places
7 decimal places
o Off
On; first value at stability
On; last value at stability
On; value bet. 70 – 130%
None
o 10 digits
20 digits
50 digits
100 digits
200 digits
500 digits
1000 digits
o No
Yes
None
o Automatic after backweighing
Automatic after initial and backweigh.
Automatic after tare, initial and backweigh
o No
Yes
No
o Yes
o No
Yes
o No
Yes
1
) Setting can only be changed
2 ) The last value with the stability
3
) To autosave a value between
2)
3)
* = Setting can only be changed when the programm is initially run
and when the Wg. seq.
o = factory setting
when the application is first run
and when the key
Wg. seq
option is set to "No"
symbol is saved only during
initial sample weighing. Tare
and backweights are saved as
the "first value at stability". This
menu option enables you to
perform filling functions during
initial weighing.
70 and 130% of the
initialization value, the scale
must be unloaded to below
30% or loaded to above 170%
of this initialization value.
key option is set to "No"