Parameters In The "Settings / Weighing / Zero/Tare" Menu; Parameters In The "Settings / Printout" Menu - Sartorius Entris II Advanced Line BCA623-1S Operating Instructions Manual

4 . 1 1 .5 Parameters in the "Settings / Weighing / Zero/Tare" Menu

Parameters Settings
Zero / tare Without
function stability
With stability*
Automatic On*
zero
Off
Zero / tare at On*
power on
Off
SQmin** On*
Off
* Factory setting
4 . 1 1 .6

Parameters in the "Settings / Printout" Menu

Parameters Settings
Printout Manual
without
stability
Manual with
stability*
Auto without
stability
Auto without
stability
Print after
weight
change
* Factory setting
Explanation
The function of the [Zero] or [Tare] button is executed immediately once the
button is pressed .
The function of the [Zero] or [Tare] button is executed if stability exists when the
button is pressed .
Activates automatic zeroing . The display is automatically set to zero in case of a
deviation of 0 less than (X) .
Deactivates automatic zeroing . Zeroing must be triggered with the [Zero]
button .
Activates the initial taring / zeroing . The device is tared or zeroed after it is
switched on .
Deactivates the initial taring / zeroing . After it is switched on, the device shows
the same value as before it was last switched off .
Activates the SQmin application .
Deactivates the SQmin application .
Explanation
The print process can be started manually at any time .
If the [Print] button is pressed: The print command is only executed once stability
is achieved .
− The data is printed automatically .
− No stability is required for printout .
− The printout can be without unit symbols .
− The data is printed automatically .
− No stability is required for printout .
Prints after a threshold for device stability has been exceeded and the weight has
previously been reduced to less than half of the threshold .
Operating Concept
Entris II Advanced Line Operating Instructions
®
23