Transport Belt - Printronix L5535 Maintenance Manual

Chapter 6
Inside The Front Cover
•
TC connector block of the transfer/separator charger
•
Varistor

Transport Belt

When replacing the transport belt, the transfer assembly must be turned
upside-down. When turning the unit upside-down, be sure to put a rest
underneath it to protect the protruding tips of the sensor levers. Also, be
careful when handling the green lever.
1. Referring to the figure below, remove the vacuum fan and disconnect its
connector.
Transfer Assembly
2. Disconnect the cables from the three (3) cable clamps.
3. Restore the transfer assembly to its original, right-side up position.
4. Referring to the figure below, remove the screws (2 on the front, 2 on the
rear) securing the output guide, then remove the output guide.
Screw (4)
Output Guide
I–272
Connector
Screw
Vacuum Fan
Green Lever
Transfer
Assembly