Power Supply (In Controller Module - Printronix L5535 Maintenance Manual

Hide thumbs Also See for L5535:

Table of Contents

Controller Module

Power Supply (In Controller Module)

1. Turn off the printer.

2. Disconnect the printer AC power cable from the power source.

3. Remove the printer left rear cover (page I–239).

4. Remove the controller module housing cover (not shown).

5. Disconnect the two harness connectors from the power supply PCBA at

the locations shown. (See the illustration on the following page.)

6. Remove the screws (4) securing the power supply to the top panel of the

controller module and remove the power supply.

7. To install the power supply, reverse the above steps.