Error Code 13 - Paper Jam At Exit (D): Straight Output (Faceup; Error Code 13 - Paper Jam At Exit (D) (Cut-Sheet Facedown Output - Printronix L5535 Maintenance Manual

NOTE: You can lower the transport unit and move the sensor lever back and
forth, while pressing the transport unit in to maintain contact with the
connector in back of the transport unit.
Error Code 13 — Paper Jam at Exit (D): Straight Output
(faceup)
CHECKLIST:
1. If there is paper remaining in the paper output section (near sensor
EPS1), remove it.
2. Ensure that the EPS1 lever is in the up position.
3. Check the EPS1 sensor.
a. Place the rotary switch in the "0" position on the MC board.
b. Put the positive lead of the digital multimeter on pin 17 of CN5 on the
MC board, and the negative lead on the SG.
c. Push the EPS1 lever down and measure the voltage; about 5V is
normal.
d. Raise the EPS1 lever up and measure the voltage; about 0V is
normal.
If voltage is not normal, replace the EPS1 sensor after checking the
harness.
NOTE: Possible causes for an EPS1 (straight) paper jam:
•
Paper may be hitting the paper guide.
•
Paper may be hitting the ceiling cover on the exit side.
•
There may be too much paper accumulated in the output tray.
•
The solenoid actuator attachment may be defective.
Error Code 13 — Paper Jam at Exit (D) (Cut-sheet
Facedown Output)
CHECKLIST:
Error Code 13 — Paper Jam at Exit (D): Straight
PAPER OUTPUT SECTION (EPS1)
EPS1 LEVER
PAPER OUTPUT SECTION (EPS2)
EPS2 (PAPER OUTPUT SENSOR 2) LEVER
I–141