Error Code 6D - Cut-Sheet Motor Fail - Printronix L5535 Maintenance Manual

Chapter 4
Status Messages And Error Messages
Error Code 6D — Cut-sheet Motor Fail
1. Check the cut sheet feeder interface harness connectors.
a. Verify that the harness connector is connected properly to MC board
b. Verify that the harness connector is connected properly to power
c. Verify that the harness connectors are connected properly to
2. Turn off power to the printer and check the continuity of the cut sheet
feeder harness wiring between the feeder and the rest of the printer.
a. Check the continuity of the harness between connector CN3 on the
b. Check the continuity of the harness between connector CN10 on the
3. Check the cut sheet pickup motor (PPM) and the cut sheet feeder motor
(PFM). Check the continuity of the harness wiring between the feeder
board and the motors.
If the problem persists, go to step 4.
4. Replace the cut sheet pickup motor (PPM) or the cut sheet feeder motor
(PFM).
If the problem persists, go to step 5.
5. Replace the feeder board.
If the problem persists, replace the cut sheet feeder.
I–166
CHECKLIST: CUT SHEET FEEDER INTERFACE HARNESS
CUT SHEET PICKUP MOTOR (PPM)
CUT SHEET FEEDER MOTOR (PFM)
FEEDER BOARD
CUT SHEET FEEDER
connector CN3, the cut sheet feeder connector on the MC board.
supply board connector CN10, the cut sheet feeder connector on the
printer DC power supply.
connectors J60101 and J03102 on the feeder board.
If the connectors are OK, go to step 2.
MC board and connector J03102 on the feeder board.
printer DC power supply board and connector J60101 on the feeder
board.
If the harness continuity is OK, go to step 3.